OEM/ODM Factory Internal Heated Soldering Iron - Zhongdi ZD-735 Solder Gun Adjustable Temperature Controlled and Fast Heating Ceramic Thermostaic 110-240V 60W 200-480℃ for Electronic Repairs – zhongdi

Features:

•Highly efficient heat transfer from element to tip
•Pointy tip perfect for repairing tiny parts
•Transparent handle, pleasing appearance
•Heats up quickly: the solder gun use a super high quality long-life ceramic core with 60W, which heat up to operating temperatures in seconds. High-performance soldering iron, up to 480°C(896°F).
•Temperature controlled with a switch: 200-480℃can be controlled freely, effectively improve work efficiency.
•High quality tip can resist oxidation, other shapes available to meet different job requirements. Easy to replace.
•Portable and easy to use: only 125g, it is very small and light weight, portable carry easily. No need soldering station, just plug and play.

Specification

Attention

With first use, the soldering iron may produce smoke. This is just grease used in manufacturing burning off.
It is normal and should only last for approx. 10 minutes. It is not harmful to the product or user.

Care of the tip

•Always keep tips coated with tin to ensure a long service life.
•Do not keep the iron at high temperature for a long time
•Never clean the tip with coarse materials
•Never cool in water.
•Remove the tip and clean every twenty hours of use, or at least once a week, and remove anything loose built up in the barrel.
•Do not use flux containing chloride or acid. Use only rosin or activated resin flux.
•Do not use any compound or anti-seize materials
•Handle the heated soldering iron with extreme care, as the high temperature of the iron can cause fires or painful burns.
•Never file the specially-plated tip.

Maintenance

•This tool must be placed on its stand when not in use.
•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard.

Operation

•1)File off any dirt, rust or paint on the part you wish to solder.
•2)Heat the part with the soldering iron.

•3)Apply rosin-based solder to the part and melt it with the soldering iron.
•Note: when using non-rosin-based solder, be sure to apply a soldering paste to the part before applying the solder.

•4)Wait for the solder to cool and harden before moving the soldered part.

Tip replacement

Note: Tip replacement or cleaning should be done only when the iron is at room temperature or below.
After removing tip, remove any oxide dust that may have formed in the tip retaining area of the barrel. Be careful to avoid getting dust in your eyes. Care should be taken not to over-tighten as it would damage the element.

General cleaning

The outer case of the iron or station may be cleaned with a damp cloth using small amounts of liquid detergent. Never submerse the unit in liquid or allow any liquid to enter the housing. Never use solvent to clean the case.